ITT Training Institute is our host for the Software Extravaganza.
(just like college, there are TBD classes based on instructor availability and student interest)
2009 AutoCad Mechanical Designer Introduction for FRC <<Postponed until 1/24/09>>
Website Development and Publishing<<Postponed until 1/24/09>>
AutoDesk 3DS Animation Simulation <<Postponed until 1/24/09>>
The agenda may change as the week progresses
2009 FRC Programmers Heaven (Sunday 1/11/09)
Bring your computer with LabView or Wind River.
There was a second update (http://joule.ni.com/nidu/cds/view/p/lang/en/id/1180).
Install the FRCLabVIEWUpdate2.0.zip(91 MB) before you come.
Bring your controls set-up if you can so you can work on your code and ask questions after lunch.
Lunch will not be provided.
Check this page before you come for last-minute information.
Location: ITT, St. Rose, LA
Time: 8-hour programming frenzy @ 8:00 AM – 4:00 PM
Goal: Training in FRC software and programming elements
Offerings: 2 separate concurrent in-depth hands-on concurrent training opportunities
· (8 hours) 2009 LabView 8.5.1 for FRC [Scot Marshall]
o (1-hour) Overview – Project and Dashboard Frameworks
o (1.5-hours) FRC Default Code VI (LabView FRC Programmer’s Manual Chap. 7 thru 36)
§ Motors, I/O, Sensors, etc.
o (0.5-hour) Modification techniques
o (1-hour) Tips, Tricks, Pit Falls, and Good Practices
o (1-hour) Q & A
o (1-hour) Lunch
o (3-hours) Hands-on support while students apply training to their project
· (8 hours) Wind River WorkBench 3.0 for FRC [MJ Miller / Blane Wesson]
o (1.5-hours) WPI Library for FRC
o (0.5-hour) Modification techniques
o (0.5-hour) Code Verification and Troubleshooting
o (0.5-hour) Tips, Tricks, Pit Falls, and Good Practices
o (0.5-hour) Q & A
o (1-hour) Lunch
o (3.5-hours) Hands-on support while students apply training to their project
|
